Format Codes for Alternate Text Editor Reference

st788796 · 发表于 2018-9-5 08:43:29

您需要登录才可以下载或查看，没有账号？立即注册

×

本帖最后由 st788796 于 2018-9-5 08:52 编辑

Format Codes for Alternate Text Editor Reference

If you use an alternate text editor, you apply formatting by entering format codes.

To apply formatting, use the format codes shown in the following table.

Format codes for paragraphs
Format code	Purpose	Enter this …	To produce this …
\0...\o	Turns overline on and off	Autodesk \OAutoCAD\o
\L...\l	Turns underline on and off	Autodesk \LAutoCAD\l
\K...\k	Turns stikethrough on and off	Autodesk\KAutoCAD\k
\~	Inserts a nonbreaking space	Autodesk AutoCAD\~LT
\\	Inserts a backslash	Autodesk \\AutoCAD
\{...\}	Inserts opening and closing braces	Autodesk \{AutoCAD\}
\Cvalue;	Changes to the specified color	Autodesk \C2;AutoCAD
\File name;	Changes to the specified font file	Autodesk \Ftimes; AutoCAD
\Hvalue;	Changes to the text height specified in drawing units	Autodesk \H2;AutoCAD
\Hvaluex;	Changes the text height to a multiple of the current text height	Autodesk \H3x;AutoCAD
\S...^...;	Stacks the subsequent text at the /, #, or ^ symbol	1.000\S+0.010^-0.000;
\Tvalue;	Adjusts the space between characters. Valid values range from a minimum of .75 to 4 times the original spacing between characters.	\T2;Autodesk
\Qangle;	Changes obliquing angle	\Q20;Autodesk
\Wvalue;	Changes width factor to produce wide text	\W2;Autodesk
\A	Sets the alignment value; valid values: 0, 1, 2 (bottom, center, top)	\A1;1\S1/2
\P	Ends paragraph	Autodesk\PAutoCAD